There are no dowels and they will be difficult to mount. In the right side of the picture below, you can see the cut layout and the number of MDF boards needed.Īs I said, this model is not ideal because the blue colored pieces mark that these will be loose. In this example we use Stacked Slices, 3mm MDF slices to pile. We transfer the modified model to Slicer for Fusion 360 where you can assign the material to use, construction technique and cut orientation. We load the STL in Fusion 360 and modify it to convert it in a pencil holder, by adding a hole and cutting the bottom to make it flatter. STL representation of the low poly Rhinoceros in Fusion 360. We will use the rhinoceros head, downloaded from the Internet. We’ll see later, but the good thing is that it let’s you see some of the stuff to avoid. I went through the whole process from scratch with a rhinoceros head, as an example while preparing the course. Cut preparation with laser cutter software. Explanation about Internet repositories with downloadable models, mainly looking for STL or OBJ models.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |